Kinect Floor Stand

Kinect Floor Stand

The kinect floor stand  is a screw together assembly for a total height of ~24". You can however adjust the total height by removing the top 12" threaded pipe (male/male) and coupling (female/female). But I was expecting to be able to adjust it to the full working range of the Kinect... didn't the manual say to mount the Kinect between 2'-6'

Anyway, there are 7 plastic peices.
1) Top base: which uses a quick connect of 2 pinchers to hold the kinect base
2) male/female reducer: male side is about the size of a camera tripod (although I dont have one so I couldn't verify that), female side is the size of a 15/16" gas threaded connector
3) male/male 12" pipe: same 15/16" gas thread connections
4) female/female coupler: same 15/16" gas thread connections
5) male/male 12" pipe: one side with 15/16" gas thread connection, bottom side uses a proprietory connection to the base
6) quick connect wire clip: clips to the bottom pipe, which is slightly larger than the upper pipe
7) tripod base with female insert for bottom pipe: this comes with either 3 rubber pads for the bottom or 3 velcro pads for use on carpet .